MkngStffAwesome
Active member
TD05 housing
TP 4070CM
Direct drive setup
Designed to be machined from 20mm aluminum

In the first pic you can see a section that is removable to to allow access to the coupler

Bearings are 9x17x5mm Ceramic (not sown)
There is an allowance for 1mm of play in and out.. The idea is i'll shim that out to be the correct distance between the housing and the compressor wheel
The total height is 62mm from the back of the housing (shown here) to where the motor mounts .. that means the motor sticks out about 170mm. With the current mounting location this should be ok.
Thoughts.
TP 4070CM
Direct drive setup
Designed to be machined from 20mm aluminum

In the first pic you can see a section that is removable to to allow access to the coupler

Bearings are 9x17x5mm Ceramic (not sown)
There is an allowance for 1mm of play in and out.. The idea is i'll shim that out to be the correct distance between the housing and the compressor wheel
The total height is 62mm from the back of the housing (shown here) to where the motor mounts .. that means the motor sticks out about 170mm. With the current mounting location this should be ok.
Thoughts.