Latest activity
-
r.brown.bayliss replied to the thread P2 Supercharger Thread.has anyone seen a map for the P2? -
Mmaticulus replied to the thread P2 Supercharger Thread.Look at the map, locate the value on the left and determine the units. If it is in meters per second (m/s) you can use the following...
-
-
I put some info into Matchbot and tried to find a similar compressor map and it gives shaft HP as an output...
-
r.brown.bayliss replied to the thread P2 Supercharger Thread.yea, so I am thinking a dual motor setup to drive the compressor, high rpm and stepping it down through the belt drive. Maybe have the...
-
NNickM replied to the thread P2 Supercharger Thread.I put some info into Matchbot and tried to find a similar compressor map and it gives shaft HP as an output...
-
r.brown.bayliss replied to the thread P2 Supercharger Thread.I did some digging, and asked a couple of AI bots, chatgpt and googles gemini, they seem to agree that turning the compressor at...
-
Mmaticulus replied to the thread E-charger on a 6.5 hp small engine carb requirements?.You have to address the pressure differential with a carburetor. If you blow through the carb you will blow against the fuel flow...
-
Wwfadams80 posted the thread E-charger on a 6.5 hp small engine carb requirements? in DIY eBoost Tech Forum.Are there any special carb requirements for putting an e-charger on a small engine, or will it work properly wit a stock setup
-
r.brown.bayliss replied to the thread P2 Supercharger Thread.You ask tricky questions :) My next step is learn all I can about batteries and motors. I have been unable to get a response from the...
-
Part number 1 has arrived :) -
Bboe replied to the thread P2 Supercharger Thread.Excited for you rbb. How/where are you sourcing your drive pulley?
-
-
r.brown.bayliss replied to the thread P2 Supercharger Thread.Well I went a head and purchased a P2, it will take about a week or so to get to NZ. Then I need to move on to thinking about powering...
