Please help. How to attach an on/off throttle switch to a brushless esc?

[ronaldrampage]

I'm attempting to build a 6s wire harness for an electric supercharger for my 223cc buggy. I want to use a trigger style throttle switch attached to the carb that only triggers at full throttle. I can't figure out how to attach the throttle switch the the speed controller. I'm new to the world of brushless and I appreciate any help. Thanks!

 

[brettus8]

If it's an ESC that requires a pwm signal , you need to convert a 12v signal from a switch mounted on the throttle to pwm. A 'servo tester' will do that but you will also need a realy to switch it on. Set the pwm signal for the speed you want and you are away.

 

[ronaldrampage]

Thanks. I'm not exactly sure if it requires a pvm signal. I'm new to all this. Attached are what I have so far for the ecs. My goal is to use a brushless 6s inline fan to run off a 24v lithium 6s battery to make a forced induction intake on my 223cc buggy. I have a brushed version that was easy to make the wire harness / trigger but I'm lost when it comes to brushless. I know it won't add actual boost but the brushed version at 24v makes a little bit more pull but i think i burnt out the motor after 2 seasons of use. I'm hoping a brushless higher amp setup and bigger main jet will give the buggy a little more at full throttle. If I had the skill to make an actual electric supercharger I bet it would make my buggy rip.

 

[brettus8]

yes it will ... you may need the instructions for the ESC for setting up the reverse/neutral/forward pwm signal.

 

[ronaldrampage]

I'm lost lol. Gonna do some more research on brushless esc