Latest activity
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.I dismissed the reservoir because a good bit of coolant would be tied up in the plumbing and I've used water to air intercooling before...
-
r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.Yes, I was thinking the case was steel, but it is aluminum so yea, ali tube. Galvanic Corrosion would be an issue with stainless and... -
-
Now you're talking because that's the kind of ingenuity I was thinking of. You could put the trans cooler in front of the ac condenser...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Now you're talking because that's the kind of ingenuity I was thinking of. You could put the trans cooler in front of the ac condenser...
-
r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.I have these, I was looking at a way to wrap with a LED light fitting heatsink. But I think all those spiral square cut valleys might be...
-
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Haven't put mine in service yet but I'm using dual 2535 Castle motors so I doubt it will be an issue. With that coil rapped around the...
-
r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.yea, maybe but it will probably have to be a custom one. What motor are you using? I looked for some a while back, but they are all...
-
-
Bbrettus8 replied to the thread RX8 Renesis Rotary eSC.Yeah ... motor sits at around 48C under there doing nothing.
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Perhaps a water cooling jacket or other motor cooling support given some of the heat soak is most certainly contributed to by the hot...
-
r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.Fans maybe?
-
Just came back from 'Mad Mike's Summerbash'. Had three one hour sessions on track . These sessions are not full blown race pace...
-
Bbrettus8 replied to the thread RX8 Renesis Rotary eSC.Just came back from 'Mad Mike's Summerbash'. Had three one hour sessions on track . These sessions are not full blown race pace...
-
Mmaticulus replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.Although a larger compressor wheel permits lower rpm speeds to achieve the desired boost pressure, theoretically the energy input needed...
-
JJeff23spl replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.Yes i was looking at some Chinese pulley to do that on T5 format....i found some that would fit a 8-10-12mm shaft. The motor shaft is...
-
JJeff23spl reacted to r.brown.bayliss's post in the thread Anyone tried a MY1020 scooter motor instead of RC motors ? with
Like.
Hi, i found this earlier and I thought it might interest you, the are T5 pulleys made to bolt to a crank and dive the P2, but they are...
