Latest activity
-
Making progress. Initially running a 28:19-20 tooth ratio depending on which gear snugs up best. My 18 tooth is on the small side and... -
r.brown.bayliss reacted to AlexLTDLX's post in the thread Compound Electric Supercharger Video Is Out with
Like.
It's been out for a few days now, so I'm sure most of you have seen it by now, but just in case you haven't, check it out - this one was... -
r.brown.bayliss reacted to StavTech's post in the thread engineering explained discusses the new porsche 992.2 with a factory e-charger. with Like.
Problem with him is he generally discusses stuff he has zero experience of, so while he understands the science of stuff, he rarely...
-
r.brown.bayliss reacted to AlexLTDLX's post in the thread engineering explained discusses the new porsche 992.2 with a factory e-charger. with Haha.
Watching him install a supercharger kit was like watching a dog chew peanut butter.
-
r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.I logged in today to aske how people were getting on with belts. I saw a reference to the T5 belts not being a good idea above...
-
SStavTech reacted to AlexLTDLX's post in the thread engineering explained discusses the new porsche 992.2 with a factory e-charger. with Like.
Watching him install a supercharger kit was like watching a dog chew peanut butter.
-
Bbrettus8 replied to the thread RX8 Renesis Rotary eSC.Might be worth me trying it with dual motors seeing as It's working so far. I figure the P2 is capable of 3-4 x more than what I've...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.If you're running the 25 mm wide belt that would help and perhaps the pulley I was running was on the small side causing more flex...
-
Bbrettus8 replied to the thread RX8 Renesis Rotary eSC.Thanks for the reply. Interestingly, I'm not seeing my belt get hot at all at around 18KW peak and 27000rpm. Could be a few factors in...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.I decided to switch to gearing after not being comfortable with the too hot to touch belt in my first build during unloaded short test...
-
Ggruntguru replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.The max power of the motor is a key metric. 7 or 8 KW is not enough to make useful boost on anything bigger than a minicar engine.
-
BI doubt it will be a problem at all considering the traditional loads the motor was designed for in a near 50lb rc car shock loading it...
-
Mmaticulus replied to the thread VESC(ted) ESC trial.I doubt it will be a problem at all considering the traditional loads the motor was designed for in a near 50lb rc car shock loading it...
-
Bbrettus8 replied to the thread VESC(ted) ESC trial.Might pay to get those gears closer in to the motor end bearing if at all possible ... shaft flex/bearing wear might become an issue...
