Latest activity
-
Mmaticulus replied to the thread Mazda RX-8 P2 build.The noise is intense despite not being anywhere near max rpm. I believe it is mostly the belt as opposed to the bearings because my...
-
Wwkerstens replied to the thread Mazda RX-8 P2 build.Belt is in, got to about 5000 motor rpm but then got scared of the 3D printed motor bracket vibrating apart. Working on the aluminium...
-
-
I didn't, thanks, that was a very interesting thread. Looks similar to what I plan to do. Got the motor controller, motor and BMS in... -
Mmaticulus replied to the thread The junkyard approach.The initial math for determining the foundational equipment is straightforward given it involves basic engine performance parameters...
-
TTussock replied to the thread The junkyard approach.I have a background as a service and repair mechanic (15 years) and have built many RC models and racing drones... 2 motors is easy...
-
Mmaticulus replied to the thread The junkyard approach.It's a Flier ESC so the durability and dependability maybe questionable from what I've read, therefore you aim for far more power...
-
TTussock replied to the thread The junkyard approach.Thanks for the reply. That ESC you're looking at is a monster. this one? https://www.ebay.com/itm/266909143317 I think the peak...
-
-
Wwkerstens replied to the thread Mazda RX-8 P2 build.I didn't, thanks, that was a very interesting thread. Looks similar to what I plan to do. Got the motor controller, motor and BMS in...
-
TLook into the Torque Amp system from Sweden.
-
Bbrettus8 replied to the thread Add 3-4psi to 1.6l.Look into the Torque Amp system from Sweden.
-
THi, I have Subaru Xv 1.6l, 114hp. Ther is some in line elec turbo can add 3-4psi? Thanks
-
r.brown.bayliss replied to the thread Mazda RX-8 P2 build.I don't know if you have seen this thread? https://www.electrifiedboost.com/threads/raspberry-p-s-i.163/ Towards the bottom of the...
-
What worked for me was dropping the “high efficiency machining” and just doing 60-80% stepover with 0.5 mm DoC and high feedrates. Yes...
-
Wwkerstens replied to the thread Mazda RX-8 P2 build.What worked for me was dropping the “high efficiency machining” and just doing 60-80% stepover with 0.5 mm DoC and high feedrates. Yes...
-
r.brown.bayliss replied to the thread Mazda RX-8 P2 build.i am getting bit chatter, its too flimsy, i am experimenting with slower feed speeds and less depth per pass. It won't hurt me if it...
