Latest activity

What's new New posts New profile posts Latest activity
  • B
    brettus8 replied to the thread RX8 Renesis Rotary eSC.
    Yes ...WHP . Add another 50 or so for crank.
  • r.brown.bayliss
    r.brown.bayliss replied to the thread RX8 Renesis Rotary eSC.
    Rotaries have no fear of RPM 🤣 Is that measured at the wheels? I assume so.
  • B
    brettus8 replied to the thread RX8 Renesis Rotary eSC.
    Have not hooked a gauge up yet but I suspect it's around 5psi lower down and 4psi up top. Is it maxed? .......... I dunno. The more I...
  • W
    wkerstens replied to the thread RX8 Renesis Rotary eSC.
    Some solid gain! How much PSI was this? Looks like this is more or less the maximum you can squeeze out of the MAX4 / 70125 setup. Would...
  • B
    brettus8 replied to the thread RX8 Renesis Rotary eSC.
    New 25T pulley installed and tested. Results below are best I've seen so far. Saw as much as 346A at 44V on the BMS Getting batteries...
    • 25T pulley.jpg
  • W
    wkerstens replied to the thread Mazda RX-8 P2 build.
    moved to your thread
  • M
    maticulus replied to the thread P2 Supercharger Thread.
    Has anyone confirmed the exducer diameter of the P2 compressor/impeller wheel? I noted the inducer diameter of ~3" but see no spec for...
  • W
    wkerstens replied to the thread Hi from Chicago Fiat 500 Super.
    Sounds like a TorqueAmp solution might work for you if you don't want to go the DIY route. Otherwise you would need to source a battery...
Show older items
Top