maticulus's latest activity
-
Mmaticulus replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.I'm pretty familiar with it and have used it quite a bit. My curiosity is with the accuracy of the power requirement for the compressor...
-
Mmaticulus replied to the thread Meth injection tuning..Assuming all here have a basic understanding of how an engine works, reducing primary fuel in exchange for the addition of a secondary...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.I dismissed the reservoir because a good bit of coolant would be tied up in the plumbing and I've used water to air intercooling before...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Now you're talking because that's the kind of ingenuity I was thinking of. You could put the trans cooler in front of the ac condenser...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Haven't put mine in service yet but I'm using dual 2535 Castle motors so I doubt it will be an issue. With that coil rapped around the...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Perhaps a water cooling jacket or other motor cooling support given some of the heat soak is most certainly contributed to by the hot...
-
Mmaticulus replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.Although a larger compressor wheel permits lower rpm speeds to achieve the desired boost pressure, theoretically the energy input needed...
-
Mmaticulus replied to the thread Meth injection tuning..It's pretty much the same thing. It really depends on what you need or want. 50/50 is just how it was always promoted back in the "stone...
-
Mmaticulus replied to the thread Meth injection tuning..I do believe that is incorrect from my experience with it. The question is the benefit ratio of 50/50 mix vs. 100%. The 50/50 ratio has...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.If you're running the 25 mm wide belt that would help and perhaps the pulley I was running was on the small side causing more flex...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.I decided to switch to gearing after not being comfortable with the too hot to touch belt in my first build during unloaded short test...
-
Mmaticulus replied to the thread VESC(ted) ESC trial.I doubt it will be a problem at all considering the traditional loads the motor was designed for in a near 50lb rc car shock loading it...
-
MUpdate : Having to bring the eSC in quite late due to surge as mentioned above was getting to me. Had been thinking about variable speed...
-
Mmaticulus replied to the thread VESC(ted) ESC trial.Making progress. Initially running a 28:19-20 tooth ratio depending on which gear snugs up best. My 18 tooth is on the small side and...
-
