maticulus's latest activity
-
MI think I finally got the VESC reliable. It took a lot of trial and error and fooling around, but in the end, I believe my setup is...
-
Mmaticulus replied to the thread S2000 Rotrex + Electric Motor.You're not running high boost so it should work fine however you could also check to see if there is a fuel injector replacement that...
-
Mmaticulus replied to the thread S2000 Rotrex + Electric Motor.I believe the injector nozzle pointing toward airflow is mostly theory and specific conditions. The idea is based on atomization but I...
-
Mmaticulus replied to the thread S2000 Rotrex + Electric Motor.You're referencing the same route option that I'm thinking without it being said. The fuel pressure access point would be a perfect...
-
Mmaticulus replied to the thread S2000 Rotrex + Electric Motor.This is the reason for the creative fuel delivery, being minimally invasive with an otherwise stock car, maintaining the ability to...
-
Mmaticulus replied to the thread S2000 Rotrex + Electric Motor.I believe a series of low to medium flow water/methanol injection nozzles might be a better option over the mechanical rising rate fuel...
-
Mmaticulus replied to the thread Meth injection tuning..My unspoken thoughts are highly influential on my plans/proposals. I've had a snow performance variable water/meth controller fail in...
-
MMy original comments were addressing a very simple scenario. 1. We have an existing boosted engine with satisfactory tuning. 2. To...
-
Mmaticulus replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.This points out the boutique nature of this subject. In order to exercise full access to the possibilities and specifics in the exact...
-
Mmaticulus replied to the thread Meth injection tuning..That's not the same as this; "also - 100% meth has an Intercooling benefit over 50:50. This is not an anti-det benefit - which is what...
-
Mmaticulus reacted to gruntguru's post in the thread Anyone tried a MY1020 scooter motor instead of RC motors ? with
Like.
The number is shaft power to drive the compressor. When you look at a compressor map from someone like BW you are looking at the result... -
Mmaticulus replied to the thread Anyone tried a MY1020 scooter motor instead of RC motors ?.I'm pretty familiar with it and have used it quite a bit. My curiosity is with the accuracy of the power requirement for the compressor...
-
Mmaticulus replied to the thread Meth injection tuning..Assuming all here have a basic understanding of how an engine works, reducing primary fuel in exchange for the addition of a secondary...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.I dismissed the reservoir because a good bit of coolant would be tied up in the plumbing and I've used water to air intercooling before...
-
Mmaticulus replied to the thread RX8 Renesis Rotary eSC.Now you're talking because that's the kind of ingenuity I was thinking of. You could put the trans cooler in front of the ac condenser...